Pin on Pinterest

This article provides tips and advice on how to tile a ceramic floor from preperation of the floor surfuce through to grouting the newly laid tiles.

A new ceramic tiled floor can really improve the look of your home. Ceramic tiles are very practicle,How to Ceramic Tile a Floor Articleshard wearing and attractive. Following the information below will help you acheive a quality ceramic tile floor in no time at all.

Step #1: Prepare the Floor

Depending on whether the floor you are tiling was previously tiled or carpeted, it will first need to be prepared for tiles to be laid. If there was carpet on the floor it will need to be removed along with any backing or glue. In addition, the surface will need to be made perfectly smooth and preferably dust-free. Keep in mind that the wood floor on which the tiles will lay needs to be as flat as possible. Otherwise, the tiles will not lay straight and water may puddle, which is unsightly and can be dangerous.

It is possible for ceramic tiles to be laid on top of other tiles, but only where the lower layer is in good condition with no cracks. Otherwise, the lower layer of tile will affect the new layer. This is why it is not recommended.

Any fasteners need to be flush with the floor and there should be no lumps, bumps or nails to compromise the integrity of the tiles. The preparation of the floor and the material used to prepare the surface for the tiles to be laid depends on the current condition of the floor. Therefore, you should research your options carefully, perhaps taking advice from the DIY shop.

Step #2: Prep Doors and Other Obstacles

Inevitably, you will have a few obstacles in your way when tiling a floor. Where a door opens into the room, whether it be a walkway door or a floor-level cupboard, you will need to trim the door bottom in order to make sure it can open smoothly and without hitting on your new tiles once they are installed.

Step #3: Get Your Trowel and Mix the Thinset

Follow the manufacturer's instructions for mixing the thinset. Just keep in mind that you should only mix as much thinset as you can use in two hours. You will also need to make sure the notch size of the trowel is the same depth as the tiles, as this gives good adhesion and also allows any air to escape after the tile is laid.

Step #4: Find the Center

You need to begin tiling from the center of the room. In order to find the centre, locate the midpoint of each wall and snap chalk lines. If this tile line bisects a unit, such as the bath or a vanity, then make sure the tile has at least 2 inches width. Otherwise, it may snap when cutting or laying and it will have a generally untidy appearance. Move the centre tile where necessary to obtain this fit. It is important, of course, to work all this out before the application of adhesive!

Step #5: Lay the Tiles

When laying your tiles, be sure to press them down ith a slight twist of the wrist. You should also use spacers in order to give a good, tidy, even fit. It is important to avoid 'lippage', where the edge of one tile is higher than the one next to it. Even pressure when laying the tiles helps with this.

You can use either a wet saw or a tile cutter to trim the tiles to size and lay them around the edges. Smaller cuts, such as those needed for going around pipework, can be made with hand cutters and a file.

Step #6: Finishing It Off

The tiles can set overnight, then scrape any residue of thinset from the tile surface or joints. Apply grout from the center of the room to the outside, pushing it in first in line with the joint, then diagonal to them. After grouting, let the tiles dry for at least 30 minutes and don't be too aggressive in wiping up the mess. Otherwise, it might pull out of the joints.

If you'd like to attempt this job yourself rather than hiring someone to do it for you, you may feel more confident after taking a course in tiling - and you will also learn more advanced techniques that can help you do an even more exciting design.

Visit them right away we have Vivanta Ceramics in different type For Example: Ceramic Tiles Manufacturer in Morbi India . They're the supply you've been hunting for.

Pin on Pinterest
Why Ceramic Tile Is The Only Tile Option You Reall

Ceramic tiles are made from fire clay. They are generally used in interior decoration, because of the low cost and exquisite look. One of the significant focal points of these tiles is that they can be used in any room. 

Cheap ceramic floor tiles are available in the market as glazed and unglazed tiles. Glazed ceramic tiles contain a coating applied to the tile body.

Glazed ceramic tiles are as of now the most well known floor alternative for all sorts of remodeling projects,

Why Ceramic Tile Is The Only Tile Option You Really Need Articles offering generally excellent attributes like low absorbability, high resistance. They are available in matte and polished finish. Glazing allows special visualizations.

Applications of Ceramic Tiles


Floor tiles: 

Ceramic tile or Wood looking ceramic tile could be a standard alternative for your interior floors and walls and offers unlimited decorating prospects.


Wall tiles:

Ceramic tiles from wall and floor tile store also can be used as wall tiles. On internal walls, they can be used to make patterns, whereas on external walls, they can be used to provide a cooling effect. This is particularly helpful during summer months.


Kitchen Countertops: 

Ceramic tiles are a prime decision for kitchen countertops, since coating makes them water and stain resistant, and they can be cleaned effectively. If you wish to possess a smooth and glossy countertop in your kitchen with less maintenance, ceramic tile is your most suitable choice. However, these tiles are vulnerable to chipping therefore care should be taken.



Because of vivid patterns & cheapness when contrasted with stone tiles, Paths through gardens are also generally made out of ceramic tiles. Also the water resistant property of ceramic tiles allows them to be more durable and long lasting.


Advantages of ceramic tiles:


Easy care: 

These tiles can be effectively cleaned and maintained. Polished ceramic tiles opposes stains, smells, dirt and can be cleaned up with a soggy mop or wipe or common cleaners.



These aren't as costly as other tile alternatives. Designer ceramic tiles are also available in the market, however, those aren’t costly too. So, if you’re looking to remodel your homes with economical tiles that additionally look nice, you know what to choose.


Fire Resistant: 

Ceramic tile doesn't burn. A lighted cigarette, when dropped on the floor, will not do any damage to ceramic tile. Indeed, even hot kitchen container or skillets won't burn or soften the surface of glazed ceramic tiles.
For more info on ceramic tiles contact experts of online tile outlet Villohome.


Visit them right away we have Vivanta Ceramics in different type For Example: Ceramic Tiles Manufacturer . They're the supply you've been hunting for.

Pin on Pinterest

Choosing tiles from the huge available variety can be very difficult task. In this article we will give you some guidance, hopefully, helping you choose the right ones.

Ceramic or stone tiles. Firstly,What tiles to choose for your home Articles choose tiles best suited for the particular room functions. There are basically two types of tiles – ceramic and stone (porcelain). Stone tiles are suitable for outdoors (terraces, balconies, steps, etc). These tiles are resistant to weather elements – frost, water, frequent temperature changes, they don’t crack. Stone tiles are made from stone dust, thermally processed. These tiles almost don’t get water saturated and don’t need any maintenance or water proofing, and they are very hard to scratching.

Ceramic tiles can only be used indoors – bathrooms, kitchens, hallways. New design trends show that tiles can be used even in living rooms. While use of ceramic tiles is limited because they are easier to scratch or break, stone tiles can be used anywhere you want.

Size of tiles. Usually we suggest our customers using smaller tiles for small bathrooms. If the ceiling is low, vertically higher tiles will help create an optical illusion of higher ceiling and if the room is very small horizontally larger tiles will help visually enlarge room (while visually lowering the ceiling). Big size tiles are very difficult to work with – surfaces have to be ideally level, need a lot of cutting if surface area is small. Usually big tiles are used together with some strip of small decorative tiles, achieving some nice design features. Small tiles or mosaic give more freedom to some design solutions – such as creating rounded corners.

Grout lines. High quality tiles can be laid with just 1mm gaps – grout lines are less visible, creating impression of the solid wall. Tiling in this way is much more difficult – tile crosses can not be used and tile guidance is done only by eye. Lower quality tiles in different packages vary by size or colour tone. These variations are minor, but still visible when gaps between tiles are small.

We always advice to grout floor tiles in darker colour – it’s much more practical, because light grout will only look nice when it is new and it’s not possible to keep that way – over time it will get dirty and it will be visible. Wall tiles usually are grouted with lighter than tiles colour grout.

Tile colours. Times when it was fashionable to have bright coloured tiles are passing. Bathrooms are now becoming relaxation rooms not only to have a shower but to relax after work or even have some romance. Too bright colours may cause changes in mood while neutral colours will always be fashionable. Presently cream or white colour tiles with some inserts of brighter tile strips are combined together with contrasting colour accessories.

Easy to clean or non slippery tiles. Sometimes people have impossible requirements for tiles – nonslippery, but easy to clean. Nonslippery tiles have a rough surface and dirt easily sticks to it – cleaning requires more efforts than smooth tiles. Specialists advice on paying more attention to safety in wet rooms (pools, bathrooms, saunas) and then only think about aspects of maintenance.

We always recommend our customers to get some extra tiles - better to have a little more than necessary. Otherwise you may have problems ordering extra tiles – colour tone or size from different order may slightly differ and you may have to wait for few weeks.

Visit them right away we have Vivanta Ceramics in different type For Example: Wall tiles Manufacturers . They're the supply you've been hunting for.

Pin on Pinterest
Useful Information On Finding Porcelain Floor Tile

Are you trying to decide which tile to use, porcelain floor tiles or ceramic tiling? Both have good and bad characteristics. They both come in unlimited variety of colors and designs. Read this article to get information on both of these tiles.

Porcelain floor tiles are among the popular types of tiles with unbelievably wide range of selection. In fact many contemporary residential and commercial buildings are using this both for functionality and decorative sense. In addition to porcelain,Useful Information On Finding Porcelain Floor Tiles Articles You can now find different patterns, textures and colors using ceramic tiling.

The wide selection of different types of tiles makes it confusing in choosing the right one that will perfectly suit your needs. Basically, tiles differ in its composition. This is usually the determining factor of the tile’s color, density and texture.

There are only three basic types of tiles based on their components. These are the Glass Tile, Porcelain Tile and Ceramic Tile. Among these three, it is the porcelain and ceramic that often confuses customers the most.

Generally, the term “ceramic” is use to refer to all types of tiles. But in reality, the composition of ceramic is pretty much different from that of porcelain floor tiles.

Ceramic tile is made of various mixed materials primarily clay and water which is processed with heat to form a solid product. Being made of porous material, the top surface of a ceramic tile is usually glazed. This determines its design, color and texture. Because its durability is known to last longer than non-tile material, this is most often preferred for ceramic tiling.

Ceramic tiling can surely last long especially if you are using these type of tile coated with high grade of glaze. Heavily glazed ceramic floor tile is also scratch and moisture resistant. Glazed ceramic tiles are also easier to clean because of its composition, since they do not absorb odor. Another advantage of having ceramic floor tiles is the fact that these will not emit toxic fumes or scorch.

Porcelain floor tiles on the other hand, are made primarily of finely-ground sand. These are very dense types of tiles that absorb water at a rate of less than 0.5%. Other than its water absorption property, these tiles have the same qualities of glazed ceramic because of its density and the natural ingredients they are made of.

Porcelain tiles have recently gaining popularity. This is because of how sales people have successfully spilled the wrong notion that this type of tiles does not need to replaced even when chipped. Contrary to what most people perceived, the latest designs of porcelain tiles do not have the same color all throughout. Hence, it should be replaced when chipped.

Those are just a few differences of porcelain floor tiles and ceramic. Both have their positive and not so positive features that seem to complement each other. If we are to compare these two based on price and durability, there is really a slight difference between these two types of tiles. But for sure the difference is barely noticeable.

Expensive and inexpensive designs are surely found on both types of tiles. Though the two differ in density, installation for both can be both easy and hard depending on how you want it done. The bottom line is deciding, which of these two types of tiles really suit your needs. Hence, you should bear this in mind before you purchase either ceramic or porcelain floor tiles.

Visit them right away we have Vivanta Ceramics in different type of tiles Manufacturers For Example: Porcelain Tiles . They're the supply you've been hunting for.

Pin on Pinterest

If you want to make any place of your home comfortable then one of the best ways to do this is to use tiles. Usage of tiles in homes has increased in recent years. The biggest advantage of tiles is that you never have to settle them. Properly installed tiles are really very easy to clean and maintain. The tiles surface does not sag,Guest Posting wear or stain. The tiles are made up of different materials. Some tiles made from natural stones that provide a beautiful and natural element. They are also available in many textures, colours, patterns and styles. Following are some different types of tiles. Ceramic Tiles: Ceramic tiles are manufactured by reducing different types of clay to a fine powder. It is the most common type of tile and it is available in different colors and styles for both walls and floors. Floor tiles are little bit thicker and stronger than wall tiles. Ceramic tiles are very hard and very easy to clean and maintain.

These types of tiles are ideal for bathrooms and kitchens. Most of the ceramic tiles are very glazy and slippery, while some un-glazy ceramic tiles are also available for floor as they are non-slippery. These tiles are very cold and hard which makes them very durable. Some special heat resistant ceramic tiles are also available for worktops. Ceramic tiles are very brittle in nature. Brick Tiles: Brick tiles are the second most commonly used tiles after ceramic tiles. Brick tiles are also known as stone tiles. These brick tiles provide a very natural look. Most of the people like to use brick tiles on their walls and this would be achieved with thin brick tiles which are stuck on to the wall very easily. The biggest advantage of brick tiles is that they are not very expensive and available in market at affordable prices. Cork Tiles: Cork tiles are very popular for the finishing of both floors and walls. Cork tiles are very thicker and stronger as compare with ceramic tiles.

The technique of laying both cork and ceramic tiles is not much different. Unlike ceramic tiles, the surface cork tile is warm. Cork tiles are very easy to cut with a sharp knife. Terracotta Tiles: These types of tiles are made from fired clay. Terracotta tiles offer a lovely warm look to any kind of surface but the disadvantage of these tiles is that they are very absorbent with moisture. These tiles are available with smooth as well as textured surfaces. You can easily cut terracotta tiles in any shape or size with the help of a sharp blade. Marble: Marble is a very popular type of tile because of its durability and beauty. Marble has been most commonly used in flooring, counter tops, hallways etc. You can easily buff out all the scratches from marble with the help of a buffer and it is a very big advantage of marble tiles. Marble tiles are available in different colors like white marble, black marble, brown marble etc.

Visit them right away we have Vivanta Ceramics is the largest manufacturer of tiles in India. They're the supply you've been hunting for.